Sea-Line antifouling

The hull was painted follow recommendations of Sea-Line manufacturer. At first layer epoxy primer and then three layers antyfoulingu Sea-Line.

The unit stayed about three months on the rich in algae Lagoon Zegrzyński. Photos illustrate the hull after the season.

“I would recommend Sea-line antifouling :)”

Sea-Line antifouling

Warning: Undefined variable $gallery_style in /home/klient.dhosting.pl/troton/sea-line.eu/public_html/wp-content/themes/Sea-Line/functions.php on line 172

Warning: Undefined variable $gallery_style in /home/klient.dhosting.pl/troton/sea-line.eu/public_html/wp-content/themes/Sea-Line/functions.php on line 172

Do you have questions about "Sea-Line antifouling"

Also check

Sensational Bandzior
Renovation of the Spanish motorboat Ducauto caribe. “Cut in half, gutted and made according to
Sensational Bandzior
Cosmetics Sea-Line in Polish Army
Cosmetics Sea-Line use in Polish Army for cleaning and protect Sea Gun AM35 on „ORP
Cosmetics Sea-Line in Polish Army
Disco Volante – Wojciech Cieślik
Mr. Wojciech Ceiślik, boatbuilder Glen-L Squirt: „I recommend Sea-Line products to everyone who builds and
Disco Volante – Wojciech Cieślik
MAK 707
„… It was not easy, hard job on knees with mask and glasses. Feeling like
MAK 707

Our FAQ answers to frequently asked questions

Possible causes

Incorrect proportion of base and herdener,
Too low temperature of ambient and surface (less than 10ﹾC),
Mixing two components from two different manufacturers,

How to prevent

Apply the correct proportions of components
Maintain steady temperature (around 20ﹾC) during the whole hardening process,
Use base and hardener from the same manufacturer

How to remove

The uncured mass requires complete removal from the surface.

Possible causes

Too short time for evaporation of the thinner,

How to prevent

Maintain the right conditions for complete evaporation of the thinner,

How to remove

Mat the surface, degrease and apply the paint according to the rule (right conditions and thinning proportions)
Polish surface if needed.

Possible causes

No thinning, wrong thinner or wrong amount of thinner
Wrong type of roll or brush (wrong bristle lenght)
Applying too much or too Little paint,
During painting process temperature was too high or the air was too dry,
Incorrect preparation of too porous surface,
Incorrect proportion of thinner.

How to prevent

Use a brush/Toller suited to the type of surface or paint,
Use thinner which is dedicated to the type of application and paints
Use thinning proportions which was indicated by manufacturer,
Paint in right atmosphere conditions indicated by manufacturer,

How to remove

Grind, clean and paint again.