Wyszukaj na stronie

Renovation Traper 300

“The entirerefurbishmentwe decided touse the products Sea-Line®.

In my opinion, a very importantelement inthe choiceof chemicals, whichwant to usefor the repair, thecorrectselection ofthe individual layerstospecificrepairandrepaired surface(laminate, steel, woodetc.)Anotherdeterminantis thespecializedhelp ona good system.

Withall responsibility, I can say thatthe technical supportprovidedby Sea-Line® isa professional andunforced, backed bya hugetheoretical and practical knowledge, and what isalso veryimportant, I had providedexcellent contactat every stage ofrenovation. “

Michał Matulka, Jacht Traper 300, Ireland

Renovation Traper 300
  • relacja z remontu jachtu traper
  • relacja z remontu jachtu traper
  • relacja z remontu jachtu traper
  • relacja z remontu jachtu traper
  • relacja z remontu jachtu traper
  • relacja z remontu jachtu traper
  • relacja z remontu jachtu traper
  • relacja z remontu jachtu traper
  • relacja z remontu jachtu traper
  • remont jachtu

Do you have questions about "Renovation Traper 300"

    Also check

    Our FAQ answers to frequently asked questions

    Why did the polyurethane topcoat become dull?

    Possible causes

    • Too short time for evaporation of the thinner,

    How to prevent

    • Maintain the right conditions for complete evaporation of the thinner,

    How to remove

    • Mat the surface, degrease and apply the paint according to the rule (right conditions and thinning proportions)
    • Polish surface if needed.

    Can I use universal thinner?

    We do not recommend using universal thinners. The use of a thinner with an unknown composition may result in loss of adhesion, lack of proper flow of paint and varnish defects.

    Why the epoxy filler does not harden?

    Possible causes

    • Incorrect proportion of base and herdener,
    • Too low temperature of ambient and surface (less than 10ﹾC),
    • Mixing two components from two different manufacturers,

    How to prevent

    • Apply the correct proportions of components
    • Maintain steady temperature (around 20ﹾC) during the whole hardening process,
    • Use base and hardener from the same manufacturer

    How to remove

    • The uncured mass requires complete removal from the surface.
    Wyjście
    Przeiń na górę