Wyszukaj na stronie
Menu

Polishing Lamb Wool Mm (White)

Made from 100% natural lamb’s wool designed to remove defects made by sandpaper, etc. Recommended for use on abrasive paper with a gradation of P1200-1500.

Product characteristics: high efficiency & elasticity

SizeColorRecommended backing plateCode
∅ 80 mmwhite“polisher” backing plate – ∅50 / “Drill” backing plate – ∅50300007468
∅ 150 mmwhite“SOFT” backing plate – ∅120 / “Universal” backing plate – ∅120300007466
∅ 180 mmwhite“Universal” backing plate – ∅150300007467
Polishing Lamb Wool Mm (White)
  • Cut level = 4

Basic information

RECOMMENDED POLISH PASTErecommendedoptional
  • S1
  • S1 PREMIUM
  • S2
  • S0
  • S05
  • S07

You have questions about the product - Polishing Lamb Wool Mm (White)

    Also check

    Our FAQ answers to frequently asked questions

    Why despite the use of antifouing paint the bottom of the boat is overgrown?

    Possible causes

    • Too thin layer of antifouling paint,
    • Choosing the wrong antifouling to type of a boat or yacht
    • Thinning of antifouling paint,
    • Incorrect surface preparation before antifouling application.

    How to prevent

    • Apply the right layer thickness of paint indicated by manufacturer,
    • Choose antifouling dedicated to type of boat or yacht and suitable for the type of water,
    • Do not thin antifouling because of the risk of reducing effectiveness,
    • Careful surface preparations (grinding, clearing, degreasing),

    How to remove

    • Wet grinding, apply new layers of antifouling paint.
    • Use C1 shell and fouling remover.

    Why does the paint have no adhesion?

    Possible causes

    • Wrong surface preparation,
    • Skipping the primer in the system application process,
    • Use of universal thinners or replacements ,
    • Paint incompatibility.

    How to prevent

    • Correct surface preparation (grinding, clearing, degreasing),
    • Use primers which improve adhesion of paints,
    • Use thinners which are dedicated to each paints,
    • Use of paints which are compatible to each other.

    How to remove

    • Grind, clean and paint again.

    Why are the streaks formed?

    Possible causes

    • Wrong viscosity and spraying technique,
    • Failure to maintain proper evaporation time and thickness of layers,
    • Incorrect spraying pressure,
    • Too low temperature of varnish, surface or space ,
    • Wrong thinner or hardener.

    How to prevent

    • Apply the right type of application method indicated by manufacturer,
    • Use working spray guns,
    • Both the object and material must have room temperature of 20ﹾC,
    • Apply correct proportion of base and hardener.

    How to remove

    • Grinding and polishing,
    • Grinding and painting,
    Wyjście
    Przeiń na górę