Wyszukaj na stronie

Employer of the Year of Pomerania 2017

We would like to share with you proud about our double victory in contest organized by North Chamber of Commerce – Employer of the Year of Pomerania 2017.

Troton, manufacturer of Sea-Line, received first award in two categories:

  • The Best Company, who employs from 51 to 250 people
  • Corporate Environmental Responsibility

Awards of competition gives in the vote :

  1. Vice- Marshal Pomerania – Mr. Jarosław Rzepa,
  2. The President of Koszalin – Mr. Piotr Jedliński,
  3. The President of Kołobrzeg – Mr. Janusz Gromek
  4. The President of Słupsk – Mr. Robert Biedroń
  5. The Mayor of Białogard – Mr. Tomasz Hynda,
  6. The Mayor of Szczecinek – Mr. Jerzy Hardie-Douglas
  7. The Mayor of Potęgowo – Mr. Dawid Litwin,
  8. The General menager of Labor Ofice in Koszalin – Mr. Henryk Kozłowski,
  9. Deputy editor-in-chief „Głos Koszaliński” – Mr. Marcin Stefanowski,
  10. The President of Kostrzyńsko-Słubicka Special Economic Zone S.A. – Mr. Krzysztof Kielec
  11. The bisness representativ – Mr. Dariusz Graj (company : Opel Dowbusz),
  12. The representativ Polish – Ukrain Economic Chamber in Szczecin – Mr. Kamil Zieliński,
  13. The representativ North Economic Chamber – Mr. Maciej Borowy (one is orginator competition),
  14. General menager in North Economic Chamber – Mr. Wojciech Brażuk,
  15. The President North Economic Chamber in Koszalinie – Mr. Roman Biłas.

Employer of the Year of Pomerania 2017

Employer of the Year of Pomerania 2017

Also check

Our FAQ answers to frequently asked questions

Why the resin does not harden?

Possible causes

  • Too low temperature of ambitne,
  • Incorrect proportion of base and herdener,
  • Mixing two components from two different manufacturers

How to prevent

  • Apply the correct proportions of components
  • Maintain steady temperature (around 20ﹾC) during whole hardening process,
  • Mix the products thoroughly and bleed the mixture.

How to remove

  • The uncured mass requires complete removal from the surface.

Why did the polyurethane topcoat become dull?

Possible causes

  • Too short time for evaporation of the thinner,

How to prevent

  • Maintain the right conditions for complete evaporation of the thinner,

How to remove

  • Mat the surface, degrease and apply the paint according to the rule (right conditions and thinning proportions)
  • Polish surface if needed.

Is it necessary to always sand the surface between application of two different products?

We recommend to always sand the surface between applying two different products to ensure uniform surface roughness and adhesion of subsequent layers. The sanded surface should also be cleaned and degreased.

Wyjście
Przeiń na górę