Wyszukaj na stronie

MS POLYMER on the WiW

MS POLYMER on the “Wind and Water”. XXX Wind and Water behind us. Among all premiers 2018 we presented MS POLYMER sealing and bonding smart solution.

The innovative dispensing solution, combined with the adhesive and sealing parameters of MS POLYMER, was awarded in the category: accessories and equipment.

MS POLYMER on the WiW

Also check

Our FAQ answers to frequently asked questions

Can I paint the bottom of the boat with polyurethane paint?

Yes, you can paint the bottom of the boat with polyurethane paint due to its high mechanical strength. We recommend this solution when the boat is not launched for a long time and is not exposed to fouling.

Can I purchase products directly from you?

We do not sell retail. Our products can be found in many stores in Poland and abroad. Our distributors run stationary and online stores. The full list of distributors and contacts can be found on our website at the following link click here.

Why the epoxy filler does not harden?

Possible causes

  • Incorrect proportion of base and herdener,
  • Too low temperature of ambient and surface (less than 10ﹾC),
  • Mixing two components from two different manufacturers,

How to prevent

  • Apply the correct proportions of components
  • Maintain steady temperature (around 20ﹾC) during the whole hardening process,
  • Use base and hardener from the same manufacturer

How to remove

  • The uncured mass requires complete removal from the surface.
Wyjście
Przeiń na górę