NEW 1K SYSTEM Sea-Line

Yes, you can paint the bottom of the boat with polyurethane paint due to its high mechanical strength. We recommend this solution when the boat is not launched for a long time and is not exposed to fouling.

Possible causes

• Too low temperature of ambitne,
• Incorrect proportion of base and herdener,
• Mixing two components from two different manufacturers

How to prevent

• Apply the correct proportions of components
• Maintain steady temperature (around 20ﹾC) during whole hardening process,
• Mix the products thoroughly and bleed the mixture.

How to remove

• The uncured mass requires complete removal from the surface.

Possible causes

• No thinning, wrong thinner or wrong amount of thinner
• Wrong type of roll or brush (wrong bristle lenght)
• Applying too much or too Little paint,
• During painting process temperature was too high or the air was too dry,
• Incorrect preparation of too porous surface,
• Incorrect proportion of thinner.

How to prevent

• Use a brush/Toller suited to the type of surface or paint,
• Use thinner which is dedicated to the type of application and paints
• Use thinning proportions which was indicated by manufacturer,
• Paint in right atmosphere conditions indicated by manufacturer,

How to remove

• Grind, clean and paint again.