Wyszukaj na stronie
Menu

S07 HEAVY CUT – revolution in polishing

S07 Heavy Cut Sea-Line is specialistic polishing paste with a very high cutting force which guarantee quick removal of defects and grinding scratches from a different kind of gelcoat  (especially for polishing of industrial gelcoat)

S07 Heavy Cut Sea-Line is primarily designed for the companies which produce goods in which the outer layer is gelcoat or forms made from utility gelcoat and an industrial topcoat with a high toughness degree.

S07 HEAVY CUT – revolution in polishing
  • s heavy cut
  • s heavy cut
  • s heavy cut
  • s heavy cut
  • s heavy cut
  • s heavy cut
  • s heavy cut
  • s heavy cut
  • s heavy cut
  • s heavy cut
  • s heavy cut
  • s heavy cut
  • s heavy cut
  • s heavy cut
  • s heavy cut
  • s heavy cut
  • s heavy cut

Also check

Our FAQ answers to frequently asked questions

Why did the polyurethane topcoat become dull?

Possible causes

  • Too short time for evaporation of the thinner,

How to prevent

  • Maintain the right conditions for complete evaporation of the thinner,

How to remove

  • Mat the surface, degrease and apply the paint according to the rule (right conditions and thinning proportions)
  • Polish surface if needed.

Why the paint does not have the right flow?

Possible causes

  • No thinning, wrong thinner or wrong amount of thinner
  • Wrong type of roll or brush (wrong bristle lenght)
  • Applying too much or too Little paint,
  • During painting process temperature was too high or the air was too dry,
  • Incorrect preparation of too porous surface,
  • Incorrect proportion of thinner.

How to prevent

  • Use a brush/Toller suited to the type of surface or paint,
  • Use thinner which is dedicated to the type of application and paints
  • Use thinning proportions which was indicated by manufacturer,
  • Paint in right atmosphere conditions indicated by manufacturer,

How to remove

  • Grind, clean and paint again.

Why are the streaks formed?

Possible causes

  • Wrong viscosity and spraying technique,
  • Failure to maintain proper evaporation time and thickness of layers,
  • Incorrect spraying pressure,
  • Too low temperature of varnish, surface or space ,
  • Wrong thinner or hardener.

How to prevent

  • Apply the right type of application method indicated by manufacturer,
  • Use working spray guns,
  • Both the object and material must have room temperature of 20ﹾC,
  • Apply correct proportion of base and hardener.

How to remove

  • Grinding and polishing,
  • Grinding and painting,
Wyjście
Przeiń na górę