Wind and Water in Katowice 2016

Sea-Line HARD and Sea-Line self-polishing antifouling are not intended for aluminum surfaces. They include copper oxide, which in contact with aluminum causes galvanic corrosion. Especially on aluminum, we offer ALU-PLUS self-polishing anti-fouling paint, which, in addition to excellent adhesion to aluminum, is also 30% more effective than traditional anti-fouling paints.

Possible causes

• No thinning, wrong thinner or wrong amount of thinner
• Wrong type of roll or brush (wrong bristle lenght)
• Applying too much or too Little paint,
• During painting process temperature was too high or the air was too dry,
• Incorrect preparation of too porous surface,
• Incorrect proportion of thinner.

How to prevent

• Use a brush/Toller suited to the type of surface or paint,
• Use thinner which is dedicated to the type of application and paints
• Use thinning proportions which was indicated by manufacturer,
• Paint in right atmosphere conditions indicated by manufacturer,

How to remove

• Grind, clean and paint again.

There is a possibility of thinning antifouling, but we do not recommend this procedure due to the risk of reducing the effectiveness of the paint. If it is necessary to thin the antifouling paint, it is recommended to dilute it to a maximum of 0-5% (by volume).