Foam Sanding Block

We recommend to always sand the surface between applying two different products to ensure uniform surface roughness and adhesion of subsequent layers. The sanded surface should also be cleaned and degreased.

Possible causes

• No thinning, wrong thinner or wrong amount of thinner
• Wrong type of roll or brush (wrong bristle lenght)
• Applying too much or too Little paint,
• During painting process temperature was too high or the air was too dry,
• Incorrect preparation of too porous surface,
• Incorrect proportion of thinner.

How to prevent

• Use a brush/Toller suited to the type of surface or paint,
• Use thinner which is dedicated to the type of application and paints
• Use thinning proportions which was indicated by manufacturer,
• Paint in right atmosphere conditions indicated by manufacturer,

How to remove

• Grind, clean and paint again.

Possible causes

• Too thin layer of antifouling paint,
• Choosing the wrong antifouling to type of a boat or yacht
• Thinning of antifouling paint,
• Incorrect surface preparation before antifouling application.

How to prevent

• Apply the right layer thickness of paint indicated by manufacturer,
• Choose antifouling dedicated to type of boat or yacht and suitable for the type of water,
• Do not thin antifouling because of the risk of reducing effectiveness,
• Careful surface preparations (grinding, clearing, degreasing),

How to remove

• Wet grinding, apply new layers of antifouling paint.
• Use C1 shell and fouling remover.