Γλώσσα:

Planet Baltic Cup 2017

Kosmetyki do naprawy łodzi oraz jachtów

Race Planet Baltic Cup started on Polish coast in 2016.  During two edition we hosted 60 boats and about 150 sailors. The regatta partners are: Seaport Kołobrzeg, Marina Kołobrzeg, Red Bull, G.Gerlach, DAD Sportswear, Hiveberg, Code Zero, Sea-Line, Neptun, Sailor Port.

Patrons: Mayor of Kołobrzeg, TVP3 Szczcin, Żagle + Jachty motorowe

III edition Planet Baltic Cup will be held on May 20 -21, IV edition – August  26 -27

The Planet Baltic Cup regatta has been included to official calendar West Pomeranian District Sailing Association in class ORC. Accept yachts taking parts in ORC traditionally will start also contestant from class Sigma Active and NHC.

Racing will start on Friday – training day

On Saturday official check in at 9:30 am. Start is scheduled at 11 am. After race all contestant are invited for party in Marina Kołobrzeg. Finish regatta is scheduled on Sunday at 14.

Planet Baltic Cup

PLANET BALTIC CUP 2017


Μετοχή:

Δείτε επίσης
Άλλα νήματα σε αυτήν την κατηγορία

Οι συχνές ερωτήσεις μας
Απαντήσεις σε συνήθεις ερωτήσεις

Why despite the use of antifouing paint the bottom of the boat is overgrown?

Possible causes

  • Too thin layer of antifouling paint,
  • Choosing the wrong antifouling to type of a boat or yacht
  • Thinning of antifouling paint,
  • Incorrect surface preparation before antifouling application.

How to prevent

  • Apply the right layer thickness of paint indicated by manufacturer,
  • Choose antifouling dedicated to type of boat or yacht and suitable for the type of water,
  • Do not thin antifouling because of the risk of reducing effectiveness,
  • Careful surface preparations (grinding, clearing, degreasing),

How to remove

  • Wet grinding, apply new layers of antifouling paint.
  • Use C1 shell and fouling remover.

Why the paint does not have the right flow?

Possible causes

  • No thinning, wrong thinner or wrong amount of thinner
  • Wrong type of roll or brush (wrong bristle lenght)
  • Applying too much or too Little paint,
  • During painting process temperature was too high or the air was too dry,
  • Incorrect preparation of too porous surface,
  • Incorrect proportion of thinner.

How to prevent

  • Use a brush/Toller suited to the type of surface or paint,
  • Use thinner which is dedicated to the type of application and paints
  • Use thinning proportions which was indicated by manufacturer,
  • Paint in right atmosphere conditions indicated by manufacturer,

How to remove

  • Grind, clean and paint again.

Is it necessary to always sand the surface between application of two different products?

We recommend to always sand the surface between applying two different products to ensure uniform surface roughness and adhesion of subsequent layers. The sanded surface should also be cleaned and degreased.

Η προσφορά μας
Εξοικειωθείτε με την προσφορά μας σε υλικά και χρώματα ναυπήγησης σκαφών
Exit
Przewiń na górę