It is very important to use paint thinners, which provide the appropriate parameters of paint – flow, pot life, time of drying.
Epoxy Lightprimer 5:1 | Brush / Roll | 5-25% |
Spray gun | 5-50% | |
Epoxy Antyosmotic HS 3:2 | Brush / Roll | 0-5% |
Spray gun | Not recommended | |
Epoxy Anticorrosiv 4:1 | Brush / Roll | 5-25% |
Spray gun | 5-50% | |
Epoxy Woodprimer 10:4 | Brush / Roll | 0-5% |
Spray gun | 20-30% |
MASKING TAPE MASKING TAPE – MASTER “AQUA” SILVER TAPE – UNIVERSAL MASKING TAPE High-quality masking tape characterized by very good adhesion […]
CORK SANDING BLOCK FOAM SANDING BLOCK PLASTIC SANDING BLOCK PROTECTIVE FOIL PAPER TOWEL (ROLL) ANTISTATIC RAGS CORK SANDING BLOCK Sanding […]
Non skid powder is anadditive for polyurethane topcoats. Non-slip powder = 20 grams, the amount for 750 ml of polyurethane […]
2-component high build epoxy primer. Does not contain laminate-penetrating solvents. Recommended for protecting yachts and boats below the waterline. Repairs […]
It is not recommended to apply 2K paints over 1K paints. 1K and 2K inks differ in their composition and properties, including hardness, chemical resistance and durability. 1K paints are one-component and dry by evaporating the solvent, while 2K paints are two-component and need to be cured by adding a hardener. Applying 2K paint over 1K paint can cause unpredictable chemical reactions and lead to undesirable effects such as dulling, chipping or flaking of the paint. Therefore, always use paints according to the manufacturer’s instructions and do not mix different types of paints. farby zgodnie z instrukcjami producenta i nie mieszać różnych rodzajów farb.
If the scratches are not deep, then we can renew the scratched side by polishing with Sea-Line polishing pastes. Above the waterline, when the scratches are not deep, the surface can be repaired with a DRY FAST gel coat filler. Deep scratches should be filled with epoxy filler (selected depending on the requirements of the scratched surface), painted with a primer and then painted with topcoat.
Sea-Line HARD and Sea-Line self-polishing antifouling are not intended for aluminum surfaces. They include copper oxide, which in contact with aluminum causes galvanic corrosion. Especially on aluminum, we offer ALU-PLUS self-polishing anti-fouling paint, which, in addition to excellent adhesion to aluminum, is also 30% more effective than traditional anti-fouling paints.
Refilling and to tackle inequalities caused by damage to or during the course of production
Protects boat surfaces from the effects of destructive activities osmosis and corrosion
Provide an aesthetic and a perfect look of the boat also protective against water and UV radiation
Protect the hull from fouling with algae and shells
Effectively remove scratches, refresh the color of gelcoat or paint, fast shine effect
Special preparations for effective cleaning and refinishing
Laminating, gluing and filling in cracks in gelcoat
Range of products useful in the boat builder work