Γλώσσα:

NOVEMBER – Time for meetings

Ιστοσελίδα » Νέα και προσφορές » NOVEMBER – Time for meetings
Producent farb jachtowych
NOVEMBER – Time for meetings

After a long break, November again becomes a meeting time for our industry. We are very pleased to invite you to visit the Warsaw Yacht Show on November 5-7 and METS Amsterdam on November 16-18.

The Warsaw event takes place for the fifth time and at that time it has gained the status of the largest yacht exhibition in Poland. It is intended for both hobbyists and professionals. It will be an opportunity to talk personally with representatives of the Sea-Line brand who will always be happy to advise you on technical issues, how and what to paint on the yacht, how to protect the hull against osmosis or fouling.

The METS Marine Equipment Trade Show is a B2B event that has been the largest event for the yacht equipment and accessories industry for many years. Traditionally, we offer free tickets for people from the industry. If you are interested, please send an e-mail to info@sea-line.eu

See you in Warsaw and Amsterdam!


Μετοχή:

Δείτε επίσης
Άλλα νήματα σε αυτήν την κατηγορία

Οι συχνές ερωτήσεις μας
Απαντήσεις σε συνήθεις ερωτήσεις

Is it necessary to always sand the surface between application of two different products?

We recommend to always sand the surface between applying two different products to ensure uniform surface roughness and adhesion of subsequent layers. The sanded surface should also be cleaned and degreased.

Do you have to paint the scratched side of the boat?

If the scratches are not deep, then we can renew the scratched side by polishing with Sea-Line polishing pastes. Above the waterline, when the scratches are not deep, the surface can be repaired with a DRY FAST gel coat filler. Deep scratches should be filled with epoxy filler (selected depending on the requirements of the scratched surface), painted with a primer and then painted with topcoat.

Why the resin does not harden?

Possible causes

  • Too low temperature of ambitne,
  • Incorrect proportion of base and herdener,
  • Mixing two components from two different manufacturers

How to prevent

  • Apply the correct proportions of components
  • Maintain steady temperature (around 20ﹾC) during whole hardening process,
  • Mix the products thoroughly and bleed the mixture.

How to remove

  • The uncured mass requires complete removal from the surface.
Η προσφορά μας
Εξοικειωθείτε με την προσφορά μας σε υλικά και χρώματα ναυπήγησης σκαφών
Exit
Przewiń na górę